Agilent Technologies 8133A Specifiche Scaricare il pdf (Pagina 24)

Chapter 3: Testing Logic Analyzer Performance

To Assemble the SMA/Flying Lead Test Connectors

2 Solder the pin strip to the SMA board mount connector:

a Solder the leads on the left side of the pin strip to the center conductor

of the SMA connector as shown in the diagram below.

b Solder the leads on the right side of the pin strip to the inside of the

SMA connector’s frame as shown in the diagram below. Use a small

amount of solder.

3 Attach the second SMA board mount connector:

a Re-heat the solder connection made in the previous step, and attach

the second SMA connector, as shown in the diagram below. Note that

the second SMA connector is upside-down, compared to the first. Add a

little solder to make a good connection.

b Solder the center conductor of the second SMA connector to the center

conductor of the first SMA connector and the leads on the left side of

the pin strip.

solder

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 103 104

Nessun commento

Agilent Technologies 8133A Specifiche Pagina 24