Agilent Technologies 603xA Guida di Installazione

INSTALLATION GUIDEAgilent TechnologiesMPS MainframeModel 66000A Agilent Part No. 66000-90001 Printed

General Information10 Options and Parts The following options are available with the mainframe: Option Description 908 Rack Mounting Kit 909 Ra

General Information11 Specifications and Supplemental Characteristics Table 1-1 lists the specifications and supplemental characteristics of the MPS

General Information12 Table 1-1. Specifications and Supplemental Characteristics (continued) INH/FLT Characteristics Maximum Ratings: ± 16.5 V bet

Installation 13 2 Installation Installation When you receive your mainframe, first look for any obvious damage that could have occurred during sh

Installation 14 Fuses The mainframe fuse is located inside the mainframe. Refer to the mainframe Service Manual for information aboutreplacing the

Installation 15 Figure 2-2. Power Cord Installation Location and Cooling Bench Operation Chapter 1 gives the dimensions of your mainframe. The

Installation 16 Rear Panel Switches The six-position rear panel switch is shown in the following figure. Figure 2-3. Rear Panel Switches Address

Installation 17 Mainframe Slot Locations/Addresses Mainframe Mode Switch = MAIN Mainframe Mode Switch = AUX Slot Location 0 1 2 3 4 5 6 7

Installation 18 Module Installation Note A fully loaded mainframe can weigh over 36 kg (80 lbs). Install the mainframe into the rack before instal

Installation 19 There must be no or minimal current flowing through the connector pins at the back of the modulethat is being removed. This can

2CERTIFICATIONAgilent Technologies certifies that this product met its published specifications at time of shipment from the factory. AgilentTechnolog

Connections 21 3 Connections Rear Panel Figure 3-1 shows where all of the rear panel connections to the mainframe are made. Figure 3-1. Rear

Connections 22 Controller Connections If you have only one MPS mainframe in your system, simply connect it to the controller using the GPIB cable.

Connections 23Figure 3-2. Controller Connections

Connections 24Figure 3-3. Digital ConnectorFLT Output Used to indicate that a fault has occurred on one of the modules in the mainframe. Pins 1 and

Connections 25Figure 3-4. Examples of the Remote Inhibit Function

Index27IndexAMaddresses, 16 MAIN, 16, 22address switch, 16 manuals, 9, 13Agilent 603xA, 10, 11, 16, 22 module, 11, 21, 22Agilent 664xA, 10, 11, 16, 22

Agilent Sales and Support OfficesFor more information about Agilent Technologies test and measurement products, applications, services,and for a curre

Manual Updates The following updates have been made to this manual since the print revision indicated on the title page. 4/15/00 All references t

3SAFETY SUMMARY The following general safety precautions must be observed during all phases of operation, service, and repair of this mainframe. Fa

4SAFETY SYMBOL DEFINITIONS Symbol Description Symbol Description Direct current Terminal for Line conductor on permanently installed equipment A

5 DECLARATION OF CONFORMITY According to ISO/IEC Guide 22 and CEN/CENELEC EN 45014 Manufacturer’s Name and Address Responsible Party Alternate M

6Table Of Contents1. General Information Introduction...

7Figures2-1. Power Cord Plug Configurations...142-2. Power Co

General Information91General InformationIntroductionThis guide describes how to install the Agilent 66000A Modular Power System (MPS) Mainframe. It i