Agilent Technologies E2094S Manuale di Servizio Scaricare il pdf (Pagina 140)

140 Agilent Connectivity Guide

6 Programming Your Instruments

Configure GPIB Card Parameters. With the GPIB interface selected

in the instrument Explorer Pane, click Change Properties... in the

Agilent 82351 PCI GPIB Interface Properties Pane on the right. The

PCI GPIB configuration dialog box appears, as shown below

1 Set the GPIB properties as required, referring to the online Help for

specific information on each property as needed. Also, verify that

this is the System Controller for the GPIB to which it is attached (this

is the typical operating mode). (See “System Controller” on

page 56.) Then, click the OK button.

2 Change/Accept the Configuration Values. When the configuration

values displayed are acceptable to you, click the OK button.

Repeat Steps for Other Interfaces. If you have installed more than one

GPIB interface in your test system, repeat the above steps for the

remaining interfaces.

Figure 49 The 82351 Configuration Dialog Box

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 217 218

Nessun commento

Agilent Technologies E2094S Manuale di Servizio Pagina 140