Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guida di Installazione Scaricare il pdf (Pagina 91)

Setting Up Multiframe Configurations 5

16900 Series Logic Analysis Systems Installation Guide 91

Creating a Simple 2-Frame w/Crossover Cable Configuration

1 Set up the two frames in the simple 100 Base-T multiframe

configuration by following the instructions in “Creating Simple

Multiframe Configurations” on page 87.

2 If the Agilent Logic Analyzer application is running on one of the

frames, exit the application.

3 Connect a special cross-over LAN cable between the two frames’

1000 Base-T LAN ports.

4 Make sure the frames’ 1000 Base-T LAN ports are enabled, and

manually set up static IP addresses for them in the network

connection’s Internet Protocol (TCP/IP) Properties dialog. Use IP

addresses in the link- local address range (169.254.xxx.xxx). Make sure

the static IP address is different for each frame; for example, use

169.254.192.0 for one frame and 169.254.192.1 for the other. (Proper

subnet masks, 255.255.0.0, are automatically filled- in.)

5 After the static IP addresses for the frames’ 1000 Base-T LAN ports

have been configured, wait about 10 seconds for the logic analyzer

service to restart.

6 Start the Agilent Logic Analyzer application, and verify that the

multiframe system appears in the Overview window.

NOTE

Use static IP addresses on the frames’ 1000 Base-T LAN ports to greatly improve the

Agilent Logic Analyzer application start up time.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 137 138

Nessun commento

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guida di Installazione Pagina 91