Agilent Technologies U1604B Manuale Utente Pagina 4

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 11
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 3
4
Acquisition: Scope Channels
Maximum sample rate 100 MSa/s per channel (50 s/div to 250 ns/div)
3
200 MSa/s single channel and interleaved (125 ns/div)
4
Equivalent sample rate U1604B: 2.5 GSa/s (125 ns/div to 10 ns/div)
Vertical resolution 8 bits
Maximum recording length: U1602B/U1604B: Up to 125 000 points, viewable on screen with zoom function
Peak detection 5 ns
Average Selectable in average number of 2, 4, 8, 16, 32, 64, 128, 256
Vertical System: Scope Channels
Analog channels Channel 1 and Channel 2 simultaneous acquisition
Bandwidth (–3 dB) U1602B: DC to 20 MHz
U1604B: DC to 40 MHz
AC coupled < 10 Hz without probe
< 1 Hz with 10 MΩ 10:1 probe
Rise time U1602B: < 17.5 ns
U1604B: < 8.8 ns
Single shot bandwidth U1602B: 20 MHz
U1604B: 40 MHz
Vertical sensitivity 5 mV/div to 100 V/div (1:1 scope probe)
50 mV/div to 1 kV/div (10:1 scope probe)
500 mV/div to 10 kV/div (100:1 scope probe)
Maximum input CAT III 300 Vrms (up to 400 Hz) from terminal to ground
Offset/Dynamic range ± 5 div
Input impedance 1 MΩ I I < 20 pF
Coupling AC, DC, GND
SCOPE SPECIFICATIONS
[1]
Vertical System: Scope Channels
Bandwidth (–3 dB) U1602B: DC to 20 MHz
U1604B: DC to 40 MHz
DC vertical gain accuracy 5 mV/div to 20 mV/div: ± 5% full scale
50 mV/div to 100 V/div: ± 3% full scale
Scope Channel Triggering
Trigger sensitivity DC to 5 MHz: 0.8 divisions
U1602B: 5 MHz to 20 MHz – 1 division
U1604B: 5 MHz to 40 MHz – 1 division
SCOPE CHARACTERISTICS
[2]
[1] All specifi cations are warranted. Specifi cations are valid after a 30-minute warm-up period and within a range of ±10 ºC from
rmware calibration temperature.
[2] All characteristics are typical performance values and are not warranted. Characteristics are valid after a 30-minute warm-up
period and within a range of ±10 ºC from fi rmware calibration temperature.
[3] Maximum sampling rates are shown here. Sampling rate will vary according to selected time base. For more information, please refer
to User’s and Service Guide.
[4] 200 MS/s sampling rate is only available at 125 ns/div timebase
[5] Number of points displayed will vary according to time base selected. For more information, refer to User’s and Service Guide
Vedere la pagina 3
1 2 3 4 5 6 7 8 9 10 11

Commenti su questo manuale

Nessun commento