Agilent Technologies ESG Manuale Utente Scaricare il pdf (Pagina 148)

140 Chapter 6

8662A/63A Commands

8662A/63A Compatible Commands

The tables in this section provide the following:

Table 6-1 on page 141: a comprehensive list of 8662A/63A programming commands, listed in alphabetical

order. The equivalent SCPI command sequence for each supported code is provided. Codes that have no

equivalent SCPI command sequence are indicated in the command column, as are codes that are not

supported by the E4438C.

Table 6-2 on page 148: a list of the implemented 8662B/63B programming commands that set the active

function. This table also indicates which codes are compatible with the increment (up), and the decrement

(down) SCPI commands.

To use the commands, select 866xA as the remote language. See “Functional E4428C/38C SCPI Commands

While in a Compatible Language Mode” on page 4 for selecting the language type.

When using the programming codes in this section, you can:

• set the ESG system language to 866xA for the current session:

Utility > GPIB/RS-232 LAN > Remote Language > 866xA

or send the command:

:SYST:LANG "8662" or "8663"

• set the ESG system language to 866xA so that it does not reset on a preset, an instrument power cycle or

a *RST command:

Utility > Power On/Preset > Preset Language > 866xA

or send the command:

:SYST:PRESET:LANG "8662" or "8663"

• set the *IDN? response to any 866xA-like response you prefer. Refer to the :SYSTem:IDNcommand on

page 3.

NOTE Compatibility is provided for GPIB only; RS-232 and LAN are not supported.

Device Clear does not preset the instrument.

To reproduce the sweep functionality, use the ESG List Sweep features.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 157 158

Nessun commento

Agilent Technologies ESG Manuale Utente Pagina 148