Agilent Technologies E8364C Manuale Utente Scaricare il pdf (Pagina 6)

E8362/3/4C

Corrected system performance continued

1. The system dynamic range is calculated as the difference between the noise floor

and the source maximum output power. System dynamic range is a specification

when the source is set to port 1, and a characteristic when the source is set to

port 2. The effective dynamic range must take measurement uncertainties and

interfering signals into account.

2. The test port system dynamic range is calculated as the difference between the

test port noise floor and the source maximum output power. The effective dynamic

range must take measurement uncertainties and interfering signals into account.

3. The direct receiver access input system dynamic range is calculated as the

difference between the direct receiver access input noise floor and the source

maximum output power. The effective dynamic range must take measurement

uncertainties and interfering signals into account. This set-up should only be used

when the receiver input will never exceed its damage level. When the analyzer is

in segment sweep mode, the analyzer can have pre-defined frequency segments

which will output a higher power level when the extended dynamic range is

required (i.e. devices with high insertion loss), and reduced power when receiver

damage may occur (i.e. devices with low insertion loss). The extended range is

only available in one-path transmission measurements.

4. Typical performance.

5. May be limited to 100 dB at particular frequencies below 500 MHz due to spurious

receiver residuals. Methods are available to regain the full dynamic range.

6. E8362C only: Option H11 decreases value by 1 dB.

7. E8362C only: Option H11 decreases value by 2 dB.

System dynamic range

Description Specification (dB) Typical (dB) at direct Supplemental information

at test port

receiver access input

Dynamic range

Standard configuration and extended power range and bias-tees (E8362/3/4C-Option UNL)

10 to 45 MHz

79 N/A

45 to 500 MHz

92 N/A

500 MHz to 2 GHz 117 N/A

2 to 10 GHz 120 N/A

10 to 20 GHz 121 N/A

20 to 30 GHz 112 N/A

30 to 40 GHz 108 N/A Option 016 degrades

40 to 45 GHz 105 N/A performance by 2 dB

45 to 50 GHz 99 N/A

Configurable test set and extended power range and bias-tees

(E8362/3/4C-Option UNL and Option 014)

10 to 45 MHz

79 129

45 to 500 MHz

5, 6

92 130

500 MHz to 2 GHz

117 136

2 to 10 GHz

120 135

10 to 20 GHz

119 134

20 to 30 GHz 109 121

30 to 40 GHz 105 117 Option 016 degrades

40 to 45 GHz 101 112 performance by 2 dB

45 to 50 GHz 95 106

1 2 3 4 5 6 7 8 9 10 11 ... 64 65

Commenti su questo manuale

Nessun commento

Agilent Technologies E8364C Manuale Utente Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Misurazione, test & controllo Agilent Technologies E8364C