Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuale di Servizio Scaricare il pdf (Pagina 202)

202 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

8 :BUS<n> Commands

Introduction to

<n> ::= {1 | 2}

The BUS subsystem commands control the viewing, labeling, and digital

channel makeup of two possible buses.

Reporting the Setup

Use :BUS<n>? to query setup information for the BUS subsystem.

Return Format

The following is a sample response from the :BUS1? query. In this case,

the query was issued following a *RST command.

:BUS1:DISP 0;LAB "BUS1";MASK +255

:BUS<n>:LABel

<string> (see

:BUS<n>:LABel? (see

<string> ::= quoted ASCII string

up to 10 characters

<n> ::= 1 or 2; an integer in NR1

:BUS<n>:MASK <mask>

(see page 209)

:BUS<n>:MASK? (see

<mask> ::= 32-bit integer in

decimal, <nondecimal>, or

<nondecimal> ::= #Hnn...n where n

::= {0,..,9 | A,..,F} for

<nondecimal> ::= #Bnn...n where n

::= {0 | 1} for binary

<string> ::= "0xnn...n" where n

::= {0,..,9 | A,..,F} for

<n> ::= 1 or 2; an integer in NR1

Table 68 :BUS<n> Commands Summary (continued)

Command Query Options and Query Returns

These commands are only valid for the MSO models.

Nessun commento

Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuale di Servizio Pagina 202