Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuale di Servizio Scaricare il pdf (Pagina 343)

100

101

:MEASure Commands 19

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 343

:MEASure:FALLtime

(see page 860)

Command Syntax

:MEASure:FALLtime [<source>]

<source> ::= {CHANnel<n> | FUNCtion | MATH | WMEMory<r>}

<n> ::= 1 to (# analog channels) in NR1 format

<r> ::= 1-2 in NR1 format

The :MEASure:FALLtime command installs a screen measurement and

starts a fall- time measurement. For highest measurement accuracy, set the

sweep speed as fast as possible, while leaving the falling edge of the

waveform on the display. If the optional source parameter is specified, the

current source is modified.

Query Syntax

:MEASure:FALLtime? [<source>]

The :MEASure:FALLtime? query measures and outputs the fall time of the

displayed falling (negative-going) edge closest to the trigger reference. The

fall time is determined by measuring the time at the upper threshold of

the falling edge, then measuring the time at the lower threshold of the

falling edge, and calculating the fall time with the following formula:

fall time = time at lower threshold - time at upper threshold

Return Format

<value> ::= time in seconds between the lower threshold and upper

threshold in NR3 format

See Also • "Introduction to :MEASure Commands" on page 330

• ":MEASure:RISetime" on page 359

• ":MEASure:SOURce" on page 362

NOTE

This command is not available if the source is FFT (Fast Fourier Transform).

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 969 970

Commenti su questo manuale

Nessun commento

Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuale di Servizio Pagina 343

Commenti su questo manuale

Prodotti e manuali riguardandi Misurazione, test & controllo Agilent Technologies InfiniiVision 3000 DSO-X 3054A