
Line Voltage
Selection
When shipped from the factory, the line voltage selector is set and an appropriate
fuse is installed for operating the instrument in the country of destination.
To operate the instrument from a power source other than the one set at the
factory:
1. Turn the rear power switch to the OFF position and remove the power cord
from the instrument.
2. Remove the fuse module by carefully prying it at the top center of the
module until you can grasp it and pull it out by hand as shown below.
Figure 2-1. Fuse Module Removal
Installation HP 1650B/1651B
2-2 Service Manual
Commenti su questo manuale