Agilent Technologies B2902 Manuale di Servizio Scaricare il pdf (Pagina 116)

3- 12 Agilent B2900 SCPI Command Reference, Edition 2

Common Commands

*SAV

This command stores the present state of the instrument to the specified location in

non-volatile memory. Up to 10 states can be stored in the memory locations 0

through 9. Any state previously stored in the same location will be overwritten. Use

the

*RCL command to retrieve instrument states.

Syntax *SAV memory

Parameter memory One of the memory locations 0 to 9. Parameter data type is NR1.

The locations 0 to 4 are in the non-volatile memory, and the

locations 5 to 9 are in the volatile memory.

Remarks If a particular state is desired at power-on, it should be stored in the location 0. It

will then be automatically recalled at power turn-on if the Output Power-On state is

set to *RCL 0.

Data described in “Non-Volatile Settings” on page 1-23 is not affected by the *SAV

command.

The *RST command does not affect the configurations stored in memory. Once a

state is stored, it remains until it is overwritten or specifically deleted.

CAUTION This command causes a write cycle to non-volatile memory. Non-volatile memory

has a finite maximum number of write cycles. Programs that repeatedly cause write

cycles to non-volatile memory can eventually exceed the maximum number of write

cycles and cause the memory to fail.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 325 326

Nessun commento

Agilent Technologies B2902 Manuale di Servizio Pagina 116