Agilent Technologies B2902 Manuale di Servizio Scaricare il pdf (Pagina 147)

Agilent B2900 SCPI Command Reference, Edition 2 4- 25

Subsystem Commands

:DISPlay[:WINDow]:DATA?

:DISPlay:VIEW?

Parameter mode SINGle1|SINGle2|DUAL|GRAPh|ROLL. Parameter data type

is CPD.

mode=SINGle1 sets the channel 1 display mode. Default setting for 1-channel

models.

mode=SINGle2 sets the channel 2 display mode. Only on 2-channel models.

mode=DUAL sets channel 1, and channel 2 display mode. Only on 2-channel

models. Default setting.

mode=GRAPh sets the graph display mode for the sweep measurement results.

mode=ROLL sets the roll display mode for the time domain measurement results.

Query response mode <newline>

mode returns SING1, SING2, DUAL, GRAP, or ROLL. Response data type is CRD.

Example :DISP:VIEW GRAP

:DISP:VIEW?

:DISPlay[:WINDow]:DATA?

Returns the data displayed on the front panel display.

Syntax :DISPlay[:WINDow[d]]:DATA?

Query response response <newline>

response returns the measured values, source output value, and sense limit value

displayed on the front panel display, as shown below. Each data is separated by a

comma. response returns ----------- (hyphen) for the empty data. Response data type

is SRD.

meas_value1,meas_value2,source_output,sense_limit

Characters  and  are converted to u and ohm, respectively.

For the SING1, SING2, or DUAL display mode, the :DISP:DATA? command

returns the data displayed on the upper display area.

For the SING1 or SING2 display mode, the :DISP:WIND2:DATA? command

returns “-----------,-----------,-----------,-----------”.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 325 326

Nessun commento

Agilent Technologies B2902 Manuale di Servizio Pagina 147