Agilent Technologies B2902 Manuale di Servizio Scaricare il pdf (Pagina 284)

4- 162 Agilent B2900 SCPI Command Reference, Edition 2

Subsystem Commands

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:TOUTput:SIGNal

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:TOUTput:S

IGNal

Selects the trigger output for the status change between the arm layer and the trigger

layer. Multiple trigger output ports can be set.

Syntax :TRIGger[c]<:ACQuire|:TRANsient|[:ALL]>:TOUTput:SIGNal output{,output}

:TRIGger[c]<:ACQuire|:TRANsient>:TOUTput:SIGNal?

For <:ACQuire|:TRANsient|[:ALL]> and <:ACQuire|:TRANsient>, specify

:ACQuire for measurement, :TRANsient for source output, or :ALL for both device

actions.

Parameter output Trigger output port.

EXT1

(default)

|EXT2|EXT3|EXT4|EXT5|

EXT6|EXT7|EXT8|EXT9|EXT10|EXT11|EXT12|EXT13|EXT14|

LAN|INT1|INT2

. Parameter data type is CPD.

output=INT1 or INT2 selects the internal bus 1 or 2, respectively.

output=LAN selects a LAN port.

output=EXTn selects the GPIO pin n, which is an output port of the Digital I/O

D-sub connector on the rear panel. n=1 to 14.

Query response response <newline>

response returns the present setting, INT1, INT2, LAN, or EXT1 through EXT14.

Response data type is CRD. Multiple responses are separated by a comma.

Example :TRIG:TOUT:SIGN EXT3

:TRIG2:TRAN:TOUT:SIGN?

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:TOUTput[:

STATe]

Enables or disables the trigger output for the status change between the arm layer

and the trigger layer.

Syntax :TRIGger[c]<:ACQuire|:TRANsient|[:ALL]>:TOUTput[:STATe] mode

:TRIGger[c]<:ACQuire|:TRANsient>:TOUTput[:STATe]?

1 2 ... 279 280 281 282 283 284 285 286 287 288 289 ... 325 326

Nessun commento

Agilent Technologies B2902 Manuale di Servizio Pagina 284