Agilent Technologies B2902 Manuale di Servizio Scaricare il pdf (Pagina 233)

Agilent B2900 SCPI Command Reference, Edition 2 4- 111

Subsystem Commands

[:SOURce]:TOUTput:SIGNal

mode=DOUBle sets the sweep mode to double sweep. Double sweep performs the

sweep from start to stop to start.

Query response mode <newline>

mode returns SING or DOUB, and indicates that the sweep mode is single or

double, respectively. Response data type is CRD.

Example :SWE:STA DOUB

:SOUR2:SWE:STA?

[:SOURce]:TOUTput:SIGNal

Selects the trigger output for the status change between the trigger layer and the

transient device action. Multiple trigger output ports can be set.

Syntax [:SOURce[c]]:TOUTput:SIGNal output{,output}

[:SOURce[c]]:TOUTput:SIGNal?

Parameter output Trigger output port.

EXT1

(default)

|EXT2|EXT3|EXT4|EXT5|

EXT6|EXT7|EXT8|EXT9|EXT10|EXT11|EXT12|EXT13|EXT14|

LAN|INT1|INT2

. Parameter data type is CPD.

output=INT1 or INT2 selects the internal bus 1 or 2, respectively.

output=LAN selects a LAN port.

output=EXTn selects the GPIO pin n, which is an output port of the Digital I/O

D-sub connector on the rear panel. n=1 to 14.

Query response response <newline>

response returns the present setting, INT1, INT2, LAN, or EXT1 through EXT14.

Response data type is CRD. Multiple responses are separated by a comma.

Example :TOUT:SIGN EXT3

:SOUR2:TOUT:SIGN?

[:SOURce]:TOUTput[:STATe]

Enables or disables the trigger output for the status change between the trigger layer

and the transient device action.

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 325 326

Nessun commento

Agilent Technologies B2902 Manuale di Servizio Pagina 233