Agilent Technologies B2902 Manuale di Servizio Scaricare il pdf (Pagina 277)

Agilent B2900 SCPI Command Reference, Edition 2 4- 155

Subsystem Commands

:ARM<:ACQuire|:TRANsient|[:ALL]>[:LAYer]:TOUTput:SIGNal

Example :ARM:TIM 2E-4

:ARM2:TRAN:TIM?

:ARM<:ACQuire|:TRANsient|[:ALL]>[:LAYer]:TOUT

put:SIGNal

Selects the trigger output for the status change between the idle state and the arm

layer. Multiple trigger output ports can be set.

Syntax :ARM[c]<:ACQuire|:TRANsient|[:ALL]>[:LAYer]:TOUTput:SIGNal

output{,output}

:ARM[c]<:ACQuire|:TRANsient>[:LAYer]:TOUTput:SIGNal?

For <:ACQuire|:TRANsient|[:ALL]> and <:ACQuire|:TRANsient>, specify

:ACQuire for measurement, :TRANsient for source output, or :ALL for both device

actions.

Parameter output Trigger output port. EXT1 (default)|EXT2|EXT3|EXT4|

EXT5|EXT6|EXT7|EXT8|EXT9|EXT10|EXT11|EXT12|

EXT13|EXT14|LAN|INT1|INT2. Parameter data type is CPD.

output=INT1 or INT2 selects the internal bus 1 or 2, respectively.

output=LAN selects a LAN port.

output=EXTn selects the GPIO pin n, which is an output port of the Digital I/O

D-sub connector on the rear panel. n=1 to 14.

Query response response <newline>

response returns the present setting, INT1, INT2, LAN, or EXT1 through EXT14.

Response data type is CRD. Multiple responses are separated by a comma.

Example :ARM:TOUT:SIGN EXT1

:ARM2:TRAN:TOUT:SIGN?

:ARM<:ACQuire|:TRANsient|[:ALL]>[:LAYer]:TOUT

put[:STATe]

Enables or disables the trigger output for the status change between the idle state

and the arm layer.

1 2 ... 272 273 274 275 276 277 278 279 280 281 282 ... 325 326

Nessun commento

Agilent Technologies B2902 Manuale di Servizio Pagina 277